Table of Contents
Advertisement
Programming
Drawing a path
7. Use the arrow buttons to move the cursor to the end point of the desired
Information
Alternatively, you can tap an arrow button once in order to define the
direction and then continue moving in this direction by pressing the pedal.
Important
Take care to ensure that the contour remains within the permissible
sewing field of your particular machine. Especially with curved paths, you
should remember that the start and end points are not directly connected
and that a curve is generated between these two points.
8. Tap the OK button.
The seam path is adopted with the specified parameters.
Adding further seam paths
You can now define all further seam paths in the same manner.
1. Add each new seam path by starting at step 4.
Deleting a seam path
1. Tap the Löschen (Delete) button.
The last section of the seam path is deleted.
Saving the program
After you have defined all the seam paths you can save the program and
specify a name for the program.
1. Tap the Speich... (Save) button.
The window for entering the program name opens.
2. Enter the desired name ( p. 101) and adopt the name by pressing
The program is now available under this name for sewing, editing or
Important
Always perform a contour test after creating a new program ( p. 113).
Ensure that the contour lies within the sewing field limits of your particular
unit.
Service Instructions 911-211 - 02.0 - 10/2016
path.
OK.
copying.
112
Advertisement
Table of Contents
