Table of Contents
Advertisement
Working basis
Fig. 15: Aligning machine head (5)
(4) - Screws
(5) - Nuts
Setting steps
1. Loosen the nuts (5).
2. Swivel down the machine head and lock it in place.
3. Use screws (4) to correct the height of the machine head at the front:
4. To adjust the locking mechanism, loosen the screws (6).
5. Move the clamp (7) up or down.
6. To test the setting, lock the machine head and check the play.
Proper setting
The locking mechanism is set correctly if the machine head can be locked
in place with ease while not showing any play at the front bearing when
moved up and down.
Service Instructions 911-211 - 02.0 - 10/2016
④
⑤
⑥
④
⑤
• higher = turn counterclockwise
• lower = turn clockwise
• To slacken the locking mechanism: Slide the clamp up
• To tighten the locking mechanism: Slide the clamp down
(6) - Screws
(7) - Block
⑦
26
Advertisement
Table of Contents
