Table of Contents
Advertisement
Programming
Service Instructions 911-211 - 02.0 - 10/2016
Symbol
Meaning
Clamp limits
Standard limits (Def.)
No additional structures are taken into account.
Special limits
Individual limits are taken into account.
Pedal mode
The following options are available:
Mode 1: The current position of the pedal is evaluated.
Mode 2 (Def.): The pedal must be returned to the initial position after every
actuation before a new actuation is recognized.
Mode 3: The current position of the pedal is evaluated.
The quick-start mode is also enabled (see Insertion mode ( p. 123)).
The machine must be switched off and on in order to enable the quick-start
mode.
Push button: In push button mode one sensor is used only for controlling
the clamp motion (up and down). The other sensor is used for starting the
sewing process.
MP2 - Limit values
Symbol
Meaning
Max. speed
(min. = 500 .. max. 1400; Def. 900 rpm)
All sewing programs are limited to this maximum speed.
Max. run-empty speed
(min. = 10 .. max. 100; Def. 100%)
Limits all clamp movements between the seams to this value.
Feed starting angle
(min. = 30 .. max. 350; Def. 300 degrees)
The clamp motion during the stitch starts at this angle of needle motion.
Feed phase
(min. = 30 .. max. 100; Def. 30%)
This parameter defines how the clamp is to be moved during the stitch.
(A value of 100% means that the desired clamp motion is distributed over
the entire stitch.)
Needle reversing position
(min. = 0 .. max. 359; Def. 0 degrees, with thread burner 20 degrees)
The needle is reversed at this angle in order to increase the clearance to
the clamp.
Edit time paths
This function is only for Dürkopp Adler Service personnel.
128
Advertisement
Table of Contents
