Table of Contents
Advertisement
Programming
Service Instructions 911-211 - 02.0 - 10/2016
MP5 - Thread clamping (for TC machines only)
Symbol
Meaning
Close thread clamp at 1st stitch
(min. = 0° .. max. 250°; Def. 180°)
Starting angle for closing the thread clamp during the first stitch.
Open thread clamp at 1st stitch
(min. = 0° .. max. 359°; Def. 340°)
Starting angle for opening the thread clamp during the first stitch.
If the closing and opening angles are the same then the thread clamp is not
activated.
MP6 - Counters
Symbol
Meaning
Counter type
The following options are available:
Piece counter increments (Def.)
The counter is incremented after each sewn program.
Piece counter decrements
The counter is decremented after each sewn program.
Sequence counter increments
The counter is incremented after each sewn sequence.
Sequence counter decrements
The counter is decremented after each sewn sequence.
Reset value for the counters
(min. = 0 .. max. 9999; Def. 0)
Value to which the counter is set when a counter reset is performed.
Seam counting for bobbin supply
(min. = 0 .. max. 100; Def. 0)
A message is displayed to the user after the number of seams specified
here have been sewn. A value of 0 deactivates the function.
Bobbin supply capacity
(min. = 0.0 .. max. 400.0; Def. 0.0m)
A message is displayed to the user after the bobbin supply capacity has
been consumed. A value of 0 deactivates the function.
130
Advertisement
Table of Contents
