Connect To A Network For Out-Of-Band Management; Connect A Management Console; Connect The Network Cables - Juniper SRX5800 Getting Started Manual

Connect to a Network for Out-of-Band Management

1. Plug the RJ-45 end of the serial cable into the appropriate CONSOLE or AUX port on the services
gateway Routing Engine.
2. Plug the other end of the cable into the network device.

Connect a Management Console

1. Plug one end of the RJ-45 Ethernet cable into the CONSOLE or AUX port on the services gateway
Routing Engine.
2. Plug the female DB-9 end into the device's serial port.

Connect the Network Cables

1. Have ready a length of the type of cable used by the interface. For cable specifications, see the SRX5800
Services Gateway Hardware Documentation at www.juniper.net/documentation/.
2. If the cable connector port is covered by a rubber safety plug, remove the plug.
WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to a
transceiver emit laser light that can damage your eyes.
CAUTION:
inserting or removing cable. The safety cap keeps the port clean and prevents
accidental exposure to laser light.
3. Insert the cable connector into the cable connector port on the faceplate as shown in
Figure 8 on page 16.
Do not look directly into a fiber-optic transceiver or into the ends of
Do not leave a fiber-optic transceiver uncovered except when you are
15