Step 7: Perform The Initial Software Configuration - Juniper SRX5800 Getting Started Manual

CAUTION:
is 58 lb-in. (6.5 Nm). The terminal studs might be damaged if excessive torque is
applied. Use only a torque-controlled driver or socket wrench to tighten nuts on the
DC power supply terminal studs.
NOTE: For information about connecting to DC power sources, see the SRX5800 Services
Gateway Hardware Documentation at www.juniper.net/documentation/.
5. Connect each DC power cable to the appropriate external DC power source.
NOTE: For information about connecting to external DC power sources, see the SRX5800
Services Gateway Hardware Documentation at www.juniper.net/documentation/.
6. Switch on the external circuit breakers to provide voltage to the DC power source cable leads.
Proceed to "Step 7: Perform the Initial Software Configuration" on page

Step 7: Perform the Initial Software Configuration

IN THIS SECTION
Enter Configuration Mode | 26
Configure User Accounts and Passwords | 26
Configure System Attributes | 27
Commit the Configuration | 28
The maximum torque rating of the terminal studs on the DC power supply
25.
25