Install The Services Gateway - Juniper SRX5800 Getting Started Manual

Install the Services Gateway

Before you install the services gateway, you must remove all components (see
page 9). To install the services gateway using a lift:
1. Ensure that the rack is in its permanent location and is secured to the building. Ensure that the installation
site allows adequate clearance for both airflow and maintenance. For details, see the SRX5800 Services
Gateway Hardware Documentation at www.juniper.net/documentation/.
2. Load the services gateway onto the lift, making sure that it rests securely on the lift platform (see
Figure 6 on page 11).
Figure 6: Load the Services Gateway onto the Lift
3. Using the lift, position the services gateway in front of the rack or cabinet, centering it in front of the
mounting shelves.
4. Lift the chassis approximately 0.75 in. above the surface of the mounting shelves, and position it as
close as possible to the shelves.
"Remove Components" on
11