SRX5600 Services Gateway Getting Started Guide
Step 5: Connect External Devices and Network Cables
Connect to a Network for Out-of-Band Management
Connect a Management Console
14
Figure 8: Connecting the Grounding Cable
Verify that the grounding cabling is correct, that the grounding cable does not touch
8.
or block access to services gateway components, and that it does not drape where
people could trip over it.
Proceed to
"Step 5: Connect External Devices and Network Cables" on page
To connect external devices and network cables:
Connect to a Network for Out-of-Band Management on page 14
Connect a Management Console on page 14
Connect the Network Cables on page 15
Turn off the power to the management device.
1.
Plug one end of the RJ-45 Ethernet cable into the appropriate
2.
services gateway Routing Engine.
Plug the other end of the cable into the network device.
3.
Plug one end of the RJ-45 Ethernet cable into the
1.
gateway Routing Engine.
Plug the female DB-9 end into the device's serial port.
2.
14.
ETHERNET
port on the
or
port on the services
CONSOLE
AUX
Copyright © 2013, Juniper Networks, Inc.