Step 1: Prepare The Site For Srx5800 Services Gateway Installation; Rack-Mounting Requirements - Juniper SRX5800 Getting Started Manual

Table 1: Minimum System Configuration (continued)
Component
Routing Engine
For detailed information about the cards supported by the services gateway, see the
and SRX5800 Services Gateway Card Reference
The services gateway is shipped in a cardboard box strapped securely to a wooden pallet. Plastic straps
secure the top and bottom in place. The services gateway chassis is bolted to this pallet. A printed copy
of this document and a cardboard accessory box are also included in the shipping container.
Step 1: Prepare the Site for SRX5800 Services
Gateway Installation
IN THIS SECTION

Rack-Mounting Requirements | 4

Tools Required to Unpack and Prepare the SRX5800 Services Gateway for Installation | 6
Rack-Mounting Requirements
You can install the services gateway in a four-post rack or cabinet or an open-frame rack.
The rack rails must be spaced widely enough to accommodate the services gateway chassis's external
dimensions: 27.75 in. (70.5 cm) high, 23.0 in. (58.4 cm) to 27.7 in. (70.6 cm) deep (depending on power
supply type), and 17.37 in. (44.11 cm) wide. The outer edges of the mounting brackets extend the width
to 19 in. (48.3 cm). See
at www.juniper.net/documentation/.
Figure 1 on page 5.
Minimum
1
SRX5400, SRX5600,
4