Table of Contents
Advertisement
June 30, 1998
SC701: ADF original table lift-up malfunction
-Definition- [B']
The bottom plate position sensor does not activate when the original table motor
lifts the original table.
- Possible causes -
• Bottom plate H.P sensor defective
• Bottom plate motor defective
• ADF main board defective
• Bottom plate position sensor defective
SC722: Finisher jogger motor error
-Definition- [B]
1) The finisher jogger H.P sensor remains de-activated for more than a certain
time when returning to home position.
2) The finisher jogger H.P sensor remains activated for more than a certain
time when moving away from home position.
- Possible causes -
• Jogger H.P sensor defective
• Jogger motor defective
SC724: Finisher staple hammer motor error
-Definition- [B]
Stapling does not finish within a certain time after the staple hammer motor
turned on.
- Possible causes -
• Staple hammer motor defective
• Staple jam
SC725: Finisher stack feed-out motor error
- Definition - [B]
The stack feed-out belt H.P sensor does not activate within a certain time after
the stack feed-out motor turned on.
- Possible causes -
• Stack feed-out H.P sensor defective
• Stack feed-out motor defective
SERVICE CALL CONDITIONS
7-23
Advertisement
Table of Contents
