Table of Contents
Advertisement
June 30, 1998
COPY PROCESS
4. DRUM POTENTIAL SENSOR
The drum potential sensor detects the electric potential on the drum to correct
various process control elements.
5. DEVELOPMENT
The magnetic developer brush on the development rollers comes in contact with
the latent image on the drum surface. Toner particles are electrostatically attracted
to the areas of the drum surface where the laser reduced the negative charge on
the drum.
6. IMAGE TRANSFER
Paper is fed to the area between the drum surface and the transfer belt at the
proper time to align the copy paper and the developed image on the drum. Then,
the transfer bias roller applies a high positive charge to the reverse side of the
paper through the transfer belt. This positive charge pulls the toner particles from
the drum to the paper. At the same time, the paper is electrically attracted to the
transfer belt.
7. PAPER SEPARATION
Paper separates from the drum as a result of the electrical attraction between the
paper and the transfer belt. The pick-off pawls also help separate the paper from
the drum.
8. ID SENSOR
The laser forms a sensor pattern on the drum surface. The ID sensor measures the
reflectivity of the pattern. The output signal is one of the factors used for toner
supply control.
9. CLEANING
The cleaning brush removes toner remaining on the drum after image transfer and
the cleaning blade scrapes off all remaining toner.
10. QUENCHING
The light from the quenching lamp electrically neutralizes the charge on the drum
surface.
1-11
Advertisement
Table of Contents
