Ricoh SP5 Series Service Manual page 231

SERVICE PROGRAM MODE
Mode No.
(Class 1 , 2 & & & & 3)
5-990 SMC Print
5 Copy Program
No. 10
6 SP
(Large Font)
6-006 DF Registration Adjustment
1 Side-to-Side
2 Leading Edge
(Thin Original)
3 Leading Edge
(Duplex-front)
4 Reading Edge
(Duplex-rear)
6-007 ADF Input Check
1 Group 1
2 Group 2
6-008 ADF Output Check
6-009 ADF Free Run (Two-sided original)
1
Function
Prints the Copy Mode list (UP Mode No.10)
See the "System Parameter and Data Lists"
section for how to print the lists.
Prints the SP mode data list with a large
font size.
See the "System Parameter and Data Lists"
section for how to print the lists.
Use SP mode when sending the SMC list
by fax.
* Adjusts the printing side-to-side registration
in the ADF mode.
Use the " • " key to toggle between + and -.
* Adjusts the original stop position.
Use the " • " key to toggle between + and -.
* Adjusts the original stop position against the
original left scale in one-sided original
mode.
Use the " • " key to toggle between + and -.
* Adjusts the original stop position against the
original left scale in two-sided original
mode.
Use the " • " key to toggle between + and -.
Displays the signals received from sensors
and switches of the ADF.
See the "Input Check" section for details.
Displays the signals received from sensors
and switches of the ADF.
See the "Input Check" section for details.
Turns on the electrical components of the
ADF individually for test purposes.
See the "Output Check" section for details.
Performs an ADF free run in two-sided
original mode. Press "1" to start.
This is a general free run controlled from
the copier. For more detailed free run
modes, see the 'Test Points/Dip
Switches/LEDs' section.
4-38
June 30, 1998
Settings
Start
Start
-3 ~ +3
0.1 mm/step
+ 0.0 mm
-29 ~ +29
0.18
mm/step
+ 0.0 mm
-29 ~ +29
0.18
mm/step
+ 0.0 mm
-29 ~ +29
0.1 mm/step
+ 0.0 mm
OFF
ON