Ricoh SP5 Series Service Manual page 360

FUSING UNIT
[G]
[C]
5. Lower the pressure spring holders [A] at both sides using a screwdriver [B] as a
lever.
6. Remove the front and rear C-rings [C], gear [D], anti-static spacers [E], isolating
bushings [F], and bearings [G].
NOTE: When installing a new hot roller:
1) Lubricate the inner and outer surfaces of the isolating bushings [F]
with BARRIERTA L55/2 grease.
2) Lubricate the fusing drive gears and their shafts with G501grease.
3) Peel off 3 cm (1 inch) from both ends of the protective sheet, and
install the new hot roller.
Before applying fusing pressure, remove the rest of the protective
sheet.
[F]
[E]
[G]
[F]
A229R652.WMF
6-88
June 30, 1998
[D]
[E]
[F]
[B]
[A]
A229R508.WMF
[C]