Table of Contents
Advertisement
DEVELOPMENT AND TONER SUPPLY
6.6.4 DEVELOPMENT ENTRANCE, FRONT, AND REAR SIDE
SEALS
[B]
1. Remove the developer. (Refer to Developer Replacement.)
2. Replace the developer entrance seal [A] (2 screws, 2 hooks).
3. Replace the front and rear side seals [B].
NOTE: When re-assembling the development unit, use new side seals and
align the edges of the side seals with the corner [C] and the edge [D]
as shown.
There is no need to change the developer with this procedure.
A229R545.WMF
[A]
A229R571.WMF
6-52
[A]
June 30, 1998
A229R546.WMF
Advertisement
Table of Contents
