Table of Contents
Advertisement
PAPER FEED
[A]
5. Re-install the by-pass paper size sensor, then reassemble the by-pass feed
table.
NOTE: When installing the table assembly, route the wires [A] correctly as
shown.
The paper guides [B] must be in the lower position as shown.
6. Calibrate the by-pass feed sensor using SP mode1-904 as follows.
1) Enter SP1-904-001 and place the side fence [C] at the A4 or 8
sideways position on the paper size decal on the table. Then press the Enter
key on the touch panel.
2) Enter SP1-904-002 and place the side fence [C] at the A6 or 4
lengthwise position on the paper size decal on the table. Then press the
Enter key.
[B]
[C]
[B]
6-76
June 30, 1998
A229R616.WMF
x 11
1/2
x 5
1/2
1/2
Advertisement
Table of Contents
