Read This Chapter Whenever You Face A Problem. (Faq); Printer Does Not Run - Roland LEF-12 Master Manual

Read this chapter whenever you face a problem. (FAQ)

Printer Does Not Run

The Printer Unit Does Not Run
Is the power switched on?
Switch on the printer's main power, then press the sub power switch and make sure the sub power switch
lights up.
 P. 10, "Switching the Power On and Off"
Is illuminated?
If is not illuminated, the printer cannot print. Complete up to setting the printer area, close the front
cover, and press
 P. 17, "Specify the print area directly"
 P. 19, "Specifying the Print Area from the Print Center Position"
Are any covers open?
Close the front cover and the panel cover.
Is the top menu displayed?
Top menu
W : mm L :
H : . mm
illuminated?
Is
If is illuminated printing is paused. To resume, press
 P. 27, "Pausing or Canceling Output"
Has ink run out?
Is a message displayed on the screen?
 P. 85, "A Message Appears"
 P. 87, "An Error Message Appears"
Is the cable connected?
Connect the cable securely.
 "First Step Guide"
80
Chapter 4 Appendix
.
mm If the top menu is not displayed, output will not start even when data is sent
from the computer. To go to the top menu, press
When data is sent while the screen shown in the figure is displayed, a message
appears and a warning beep sounds. At the same time, operation pauses. When
the ink cartridge is replaced with a new one, output resumes.
 P. 54, "How to Replace the Ink Cartridge"
, then press
. goes out, and output resumes.
.