Adjustment Of The Longitudinal Position - Stiga T 102 Series Workshop Manual

WORKSHOP MANUAL
T...102/122 - TC...102/122
B) Adjustment of the longitudinal position
Put the machine onto a flat and stable surface (such
as a work bench) and put blocks beneath the cutting
deck in line with the centre lines of the blades:
– at the front 26 mm (1)
– at the rear 32 mm (2)
1 - h = 26 mm
1 - 2
2 - h = 32 mm
then set the lifting lever to position «1» and slacken
off the nuts (3), screws (5) and locknuts (4 - 6) on both
the right and left hand sides, so that the deck rests
firmly on the blocks.
4 3
7
9 8
10
B
ALIGNING THE CUTTING DECK
Slacken off the nuts (8) and locknut (9) of the two front
connecting rods (10) and adjust nuts (8) of the front
left con necting rod to set the exact distance «A» of:
between the centre of the engine pulley hub and the
centre of the left blade shaft.
11a
This operation is facilitated by using the checking cali-
per (11) suitably positioning the engine side terminal
(11a) at the side marked with «CLUTCH»
Distance «B» is set by using the corresponding front
right connecting rod nuts to obtain the same meas-
urement, so that the outlet is perfectly centred with
respect to the collector channel; then fully tighten the
nuts (8) and locknut (9).
5
NOTE It is very important that distance «B» is the
8
same on both the left and right hand sides, to prevent
the belt from rub bing against the collectorn channel.
6
Turn both the rear screws (5) until the rear of the deck
begins to rise both at the right and the left, and then
tigh ten the relevant locknuts (6).
– 489 mm (mod. 102)
– 474 mm (mod. 122)
11a 11
A
CHAPTER REVISION FROM ...
4.5 0 2018
Push the two connecting rods (7) to the back and
screw down the two nuts (3) on each rod until the front
part of the deck just begins to rise both at the right and
the left, and then tighten the relevant locknuts (4).
PAGE
2 of 2