Removing The Dashboard And Front Cover - Stiga T 102 Series Workshop Manual

WORKSHOP MANUAL
T...102/122 - TC...102/122
Validity
General informations
The dashboard is removed to make the following
mo re accessible:
– the accelerator;
– the ignition block,
– various electrical components.
With some drives it could be necessary to re­
move the dashboard before it is possible to dis­
mantle the fuel tank.
Related topics
---
Map of functional units
REMOVING THE DASHBOARD
AND FRONT COVER
A) Removing the dashboard
Use a 5 mm diameter round bar to remove the pin (1)
and take out the steering wheel (2).
Disconnect the end of the accelerator cable from the
engine and disconnect all electrical connections and
the starter cable (where fitted).
At this point it is possible to remove the dashboard,
which is fixed to the frame by four self-threading
screws (3) and (4).
NOTE The screws (3) are covered by pla stic caps on
some models.
2
1
On reassembly, on
some models, the di-
rection of the springs
(5) must be adjusted
in relation to the po-
sition of the hood, to
ensure fastening.
CHAPTER REVISION
5.4
B) Removing the front cover
Remove the dashboard [see point "A"].
12
3
Remove the parking brake lever knob (11) or (12) and
dismantle the front guard (13) fixed to the chassis by
six screws (14).
4
3
5
FROM ... PAGE
0 2018 1 of 1
11
13
14
14