Removal Of The Cutting Deck - Stiga T 102 Series Workshop Manual

WORKSHOP MANUAL
T...102/122 - TC...102/122
Validity
General informations
Removing the cutting deck facilitates all opera­
tions involving the blade connecting toothed belt
and the overhaul and replacement of the hubs,
bea rings or blade shafts.
With some practice and experience it is possible
to do this work with the deck still in position.
Related topics
[ 4.5] Aligning the cutting deck
[ 5.3] Removal of the collector channel
Map of functional units

REMOVAL OF THE CUTTING DECK

Remove the collector channel..
After having put the cutting height lever in position
«1», loosen the engagement cable adjuster (1) and
take it out
2
Unscrew the two nuts (6) of the two front connec ting
rod pins (7), without loosening or changing the posi-
tion of thenuts (8) and locknuts (9).
Remove the two split-pins (10) of the rear pins and
then, having checked that there are no obstructions,
the deck can be removed by extracting it in such a
way that all the pins leave their housings.
9
CHAPTER
5.7
On reassembly ensure that the two rear holes of the
corner joints are used for fixing the pins (7), without
locking the relative nuts (6).
1
6
10
After having restored all the connections, ...
Refit the collector channel.
If the nuts and locknuts (8 – 9) were accidentally
moved...
The deck must be properly adjusted.
8
6
8
7
REVISION FROM ... PAGE
0 2018 1 of 1
8 7 8 9