Fuel Control (Accelerator) (12:E); Throttle (If Applicable) (12:G); Ignition Block (12:F); Steering Wheel (13:E) - Stiga P 901 C Series Operator's Manual

EN
6.5 FUEL CONTROL
(12:E)
Used to adjust engine speed.
Full gas - to be used always when using
the machine.
Minimum.
6.6

THROTTLE (IF APPLICABLE) (12:G)

Control to close the throttle in case of cold starts.
Control fully out (12:G1) - throttle closed.
For cold starting the engine.
Control fully in (12:G2) - throttle open. For hot
starts and while driving.
When the engine is hot, do not pro-
ceed with the throttle closed.
Some models are equipped with a
system that automatically controls the
position of the choke in the carburet-
tor during engine start-up and warm-
ing-up.
6.7

IGNITION BLOCK (12:F)

The ignition block is used to start and stop the
engine.
When leaving the driver's seat, do not
leave the key in position 2 or 3. There is
a risk of fire - fuel can enter the engine
through the carburettor - and the bat-
tery will deplete and be damaged.
The four key positions:
1. Stop position - the motor is short-circuit-
ed. The key can be removed.
2/3. On position.
4. Ignition position - turning the key to this
position activates the starter motor.
When the engine is running, release the
key, which returns to the on position.
14
ENGLISH
(ACCELERATOR)
(Translation of the original instructions)
6.8

STEERING WHEEL (13:E)

• Type "II" steering wheel
The height of the steering wheel is infinitesimal
adjustable. Unscrew the steering adjustment
knob (13:D) to raise or lower the steering wheel
to the desired position. Tighten.
Do not adjust the steering wheel while
driving.
Never turn the steering wheel when the
machine is stationary with an attach-
ment lowered. There is a risk of abnor-
mal loads on the power steering and
steering components.
6.9

CUTTING HEIGHT ADJUSTMENT (12:B)

Control for using the cutting device with electric
cutting height regulator.
The switch allows for continuous cutting
height adjustment.
The cutting device assembly is connected
to the socket (13:C).

6.10 POWER SOCKET (12:A)

Control for connecting and disconnecting the
power socket which activates the attachments
mounted on the front.
The power socket must never be en-
gaged when the front attachment lift is
in the transport position. This will de-
stroy the belt transmission.
Power socket on/off button (12:A).
Press the button to switch the pow-
er socket on/off.

6.11 BLUETOOTH (IF APPLICABLE)

Some models are equipped with a Bluetooth
function, which allows direct wireless connection
between the machine and a device over a short
distance.
The device must have the appropriate App for
data exchange installed, whose instructions for
use are provided separately.
Bluetooth is activated when the machine is
turned on and deactivated when the machine is
turned off.
Check that the connection to the device/App is
active.