Removal Of The Wheel Cover - Stiga T 102 Series Workshop Manual

WORKSHOP MANUAL
T...102/122 - TC...102/122
Validity
General informations
Removing the wheel cover gives access to:
– the mount for the lever to raise the deck;
– the supports of the footboards.
Related topics
---
Tightening torques
9 Lower cover fixing screw ...............4,0 ÷ 4,5 Nm
10 Upper cover fixing screw ............ 4,0 ÷ 4,5 Nm
Map of functional units

REMOVAL OF THE WHEEL COVER

Remove the spring (1) fixing the battery, ensuring that
accidental short circuits are not caused; first discon-
nect the black cables (earth), then the red cable (posi-
tive) and remove the battery (2).
Remove the caps (5) from the springs and undo the
screws inside (6).
2
5
6
Remove the seat after having dismantled the two pins
(7).
7
CHAPTER
5.2
The cover (8) is fixed by two screws (9) located un der
the side footboards and two screws (10) fixing it to the
rear plate.
1
9
7
REVISION FROM ... PAGE
0 2018 1 of 2
9 8 10
The cover (8) can be
removed after the cut-
ting height adjustment
lever has been set to its
highest position.
8 10