Replace The Engine Air Filter Element - Deutz Models - Genie GS-3390 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
14 Securely connect the black wire of the
maximum height limit switch wire harness to
terminal A10 of the terminal strip.
15 Securely connect the white wire of the
maximum height limit switch wire harness to
terminal B9 of the terminal strip.
16 Turn the key switch to platform control.
17 Fully raise the platform. Release the joystick.
Result: The platform should stop raising at
maximum height. The engine should continue
to run and an alarm should not sound.
Result: The engine stops OR an alarm sounds.
Refer to Repair Procedure 12-1, Calibrate the
Platform Overload System (if equipped).
18 Lower the platform to the stowed position.
19 Disconnect the platform controls from the ECM
wire harness.
20 Securely connect the platform controls wire
harness to the ECM wire harness.
21 Securely connect the platform controls to the
platform controls wire harness at the platform.
3 - 30
C-2
Replace the Engine Air Filter
Element - Deutz Models
Engine specifications require that this procedure
be performed every 500 hours or semi-annually,
whichever comes first.
Maintaining the engine air filter in good condition is
essential to good engine performance and service
life. Failure to perform this procedure can lead to
poor engine performance and component damage.
Note: Perform this procedure with the engine off.
1 Release the latches on the engine tray and fully
slide the engine tray out.
2 Insert a 6 inch / 15 cm screwdriver or rod into
the engine tray lock hole located near the
engine tray roller wheels to prevent the engine
tray from moving.
3 Remove the air intake hose from the engine
slide out tray.
4 Disconnect the retaining clamp from the air
cleaner canister.
5 Remove the filter element.
6 Clean the inside of the canister and the gasket
with a damp cloth.
7 Install the new filter element.
8 Install the air filter canister end cap and connect
the end cap retaining clamp.
Note: Be sure the air cleaner intake hose is
inserted in the hole in the front of the engine slide
out tray.
GS-3390 • GS-4390 • GS-5390
July 2007
REV E
Part No. 72863