Table of Contents
Advertisement
Unpack the PTX10003
Move the shipping carton to a staging area as close to the installation site as possible, but where you have enough room to
1.
remove the system components.
Position the carton so that the arrows point upward.
2.
Open the top flaps on the shipping carton.
3.
Remove the accessory kit.
4.
Pull out the packing material holding the PTX10003 in place.
5.
Verify the following components are in the box:
6.
For the PTX10003-160C, the router chassis with five fan modules and four power supplies installed. For the PTX10003-80C,
the router chassis with three fan modules and two power supplies installed.
Two side-mounting blades with rails attached to each side of the chassis.
For PTX10003-160C AC/HVDC installations, four power cords with plugs that are appropriate for your geographical location.
For PTX10003-80C AC/HVDC installations, two power cords with plugs that are appropriate for your geographical location.
NOTE:
Power cords are not provided for DC installations.
RJ-45 cable and RJ-45 to DB-9 serial port adapter
Accessory kit containing:
DC power cable lug (for DC installations)
Four M4 x 8 mm flat head screws
Four M5 x 10 mm pan head screws
End User License Agreement
One DB-9-RJ to RJ-45 serial port adapter, straight through cable
Cable management assembly
Road Map card
Save the shipping carton and packing materials in case you need to move or ship the chassis later.
7.
Mount the PTX10003 in a Rack
The mounting rails and mounting blades are preattached to the PTX10003. To mount the chassis in a 19-in (48.26 cm) four-post
rack, you simply remove one screw to release the sliding rail and then attach the mounting blades to the rack. The sliding mounting
rails enable the PTX10003 to be mounted flush with the rack and still be adjustable for racks with different depths. The minimum
distance the front and rear rack rails can be spaced apart is 26 in. (66.04 cm) front to back. The maximum distance the front
and rear rack rails can be spaced apart is 36 in. (91.4 cm) front to back.
WARNING:
PTX10003 routers must be supported at all four corners.
CAUTION:
PTX10003 routers require at least three people for installation, two people to lift the device into place
and another person to attach the device to the rack. You can remove the power supplies and fan modules to minimize
Copyright © 2018, Juniper Networks, Inc.
PTX10003-80C and PTX10003-160C Quick Start Guide
3
Advertisement
Table of Contents
