Table of Contents
Advertisement
PTX10003-80C and PTX10003-160C Quick Start Guide
root@# set routing-options static route default next-hop address
Configure the IP address and prefix length for the management interface.
8.
[edit]
root@# set interfaces re0:mgmt-0 unit 0 family inet address address/prefix-length
NOTE:
The RJ-45 management port is labeled
(Optional) Configure the static routes to remote prefixes with access to the management port.
9.
[edit]
root@# set routing-instances mgmt_junos routing-options static route remote-prefix next-hop destination-ip retain no-readvertise
Enable the Telnet service.
10.
[edit]
root@# set system services telnet
NOTE:
When Telnet is enabled, you cannot log in to a PTX10003 through Telnet by using root credentials. Root
login is allowed only for SSH access.
Commit the configuration to activate it on the PTX10003.
11.
[edit]
root@# commit
Safety Warnings Summary
This is a summary of safety warnings. For a complete list of warnings, including translations, see the PTX10003-80C and
PTX10003-160C Fixed Packet Transport Router Hardware Guide.
The following guidelines help ensure your safety and protect the device from damage. The list of guidelines might not address
all potentially hazardous situations in your working environment, so be alert and exercise good judgment at all times.
Perform only the procedures explicitly described in the hardware documentation for this device. Make sure that only authorized
service personnel perform other system services.
Keep the area around the device clear and free from dust before, during, and after installation.
Keep tools away from areas where people could trip over them while walking.
Do not wear loose clothing or jewelry, such as rings, bracelets, or chains, which could become caught in the device.
Wear safety glasses if you are working under any conditions that could be hazardous to your eyes.
Do not perform any actions that create a potential hazard to people or make the equipment unsafe.
Never attempt to lift an object that is too heavy for one person to handle.
Never install or manipulate wiring during electrical storms.
Never install electrical jacks in wet locations unless the jacks are specifically designed for wet environments.
Operate the device only when it is properly grounded.
Ensure that the separate protective earthing terminal provided on this device is permanently connected to earth.
Replace fuses only with fuses of the same type and rating.
10
and the SFP management port is labeled
mgmt-0
.
mgmt-1
Copyright © 2018, Juniper Networks, Inc.
Advertisement
Table of Contents
