Table of Contents
Advertisement
If the AC/HVDC power source outlet has a power switch, set it to the on (
7.
Verify that the status LEDs on each power supply are lit green.
8.
If the status LED is lit amber, remove power from the power supply, and replace the power supply (see Replacing an AC/HVDC
Power Supply in the PTX10003). Do not remove the power supply until you have a replacement power supply ready.
Perform the Initial Configuration
You'll need to perform the initial configuration of the PTX10003 through the console port using the CLI or through Zero Touch
Provisioning (ZTP). To provision the PTX10003 using ZTP, you'll need access to a Dynamic Host Control Protocol (DHCP) server
and a File Transfer Protocol (anonymous FTP), Hypertext Transfer Protocol (HTTP), or Trivial File Transfer Protocol (TFTP)
server on which the software image and configuration files are stored.
Before you begin connecting and configuring a PTX10003, set the following parameter values on the management console or
console server:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
To connect and configure the PTX10003 using the CLI:
Connect the console port to a laptop or PC by using the supplied RJ-45 cable and RJ-45 to DB-9 adapter. The console port
1.
(labeled
CON
) is located on the management panel of the PTX10003 (see Connecting the PTX10003 to a Management
Console).
Log in as root. A password is not required. If the software boots before you are connected to the console port, you might need
2.
to press the Enter key for the prompt to appear.
login: root
Start the CLI.
3.
root@% cli
Enter configuration mode.
4.
root> configure
Add a password to the root administration user account.
5.
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
(Optional) Configure the name of the PTX10003. If the name includes spaces, enclose the name in quotation marks (" ").
6.
[edit]
root@# set system host-namehost-name
Configure the default gateway.
7.
[edit]
Copyright © 2018, Juniper Networks, Inc.
PTX10003-80C and PTX10003-160C Quick Start Guide
) position.
|
9
Advertisement
Table of Contents
