Auto-Stop - Precor TRM 885.v2 Service Manual

Auto-Stop

The Auto Stop feature monitors the current used to drive the walk/run belt. The current bursts
necessary to overcome foot plants and the resultant increase in friction indicates a user is present.
The lack of current bursts indicates that a user is not present. If the running belt is moving and the
Auto Stop does not detect motion from the belt drive, the Auto Stop feature will stop the motion of
the running belt.
The auto-stop feature is controlled electronically via the Motor Controllers software. When a
program is entered, Quick Start is pressed or the treadmill has been resumed after being paused,
the treadmill starts at 1 mph. The user will then have 60 seconds to enter any remaining workout
settings before motion detection begins. Once motion detection has commenced and if no or very
little motion is detected, the Auto Stop feature interprets that the treadmill is no longer in use. The
Auto Stop feature will continue to monitor the treadmill for motion for 30 seconds; if a user is still not
detected a 10 second count down will be displayed on the console. After the 10 second count down
has elapsed and a user has not been detected, the Auto Stop feature will stop the motion of the
running belt and go into pause mode. If a user is detected within the 10 second count down cycles
the shutdown feature will be aborted.
The Auto Stop feature can be enabled or disabled within the service software menus. See "Setting
Club Parameters" in the corresponding P10, P30 or the P80 console service manual.
Note: If enabled, adjustment and tracking procedures should be performed while in the
Hardware Validation – Belt Speed Test. This is because the Auto-Stop feature is not active
during the Belt Speed Test.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 30