THOMSON Speedtouch 600 Series Orientation Manual page 42

3 The SpeedTouch™610 Web Interface
NAPT
38
Click this link to display the Network Address and Port Translation (NAPT) page.
This page allows you to:
• View or add/delete specific static NAPT entries:
You can add static NAPT entries by
1 Click New.
2 Specify the outside address and inside address for the entry as well as the
protocol and port on which the entry applies.
Note If the NAPT entry is applied to a connection's dynamically
assigned local peer IP address, you should specify 0.0.0.0 as the
outside address.
3 Click Apply to add the entry to the table.
You can also add static NAPT entries semi-automatically using the SpeedTouch™
NAPT Manager. For more information on NAPT Manager, see
NAPT Manager" on page
•
View or add/delete Multi-NAT Entries:
Multi-NAT is also commonly known as Basic NAT (IETF). To add Multi-NAT
Entries proceed as follows:
1 Click New.
2 Specify the inside address and put the desired range between brackets e.g.
10.0.0.[1-10]. Specify the outside address and interface.
3 Click Apply.
57.
"3.8 SpeedTouch™
E-SIT-CTC-20030306-0004 v2.0