Table of Contents
Advertisement
The configuration
procedure
E-SIT-CTC-20030306-0004 v2.0
The configuration procedure proceeds as follows:
1
As soon the wizard detected your SpeedTouch™610, some device details are
shown. In case multiple SpeedTouch™ devices reside on your local LAN, a listing
of devices is shown from which you can select the appropriate one.
Click Next to proceed.
Note
If the SpeedTouch™610 has been configured before:
•
It may be protected by a system password. Before you are able to
view the device details or continue with the configuration this
password has to be entered.
•
You will be asked to choose between reconfiguring your Speed-
Touch™610 or changing your Local Area Network configuration.
Select the Reconfigure the SpeedTouch™ option and click Next.
2
The following window invites you to select the appropriate connection profile for
your Internet connectivity:
Select the connection profile and click Next to continue.
Note
In case the Service Provider included a separate disk with a dedicated
connection profile, click Have Disk to browse to the location of the
appropriate connection profile file.
3
Subsequent screens will guide you through the configuration setup of both the
SpeedTouch™610 and/or your PC. Follow the instructions and enter the required
information where needed.
The needed information will depend on the selected connection profile and
should be provided by your Service Provider.
Click Next whenever requested.
4
After configuration, the SpeedTouch™610 will restart. In some cases your PC
must be restarted as well for the changes to take effect:
1 SpeedTouch™610 Installation
15
Advertisement
Table of Contents
