Table of Contents
Advertisement
1 SpeedTouch™610 Installation
1.2 SpeedTouch™610 Wiring
Local network
Ethernet Cables
Wiring procedure
More information on
Ethernet wiring
Single PC wiring
8
For Ethernet connectivity you need at least:
•
A computer with installed Ethernet Network Interface Card (NIC)
•
If needed, a hub or switch and the necessary connection cables
In the SpeedTouch™610 box, a full wired Cat.5 straight-through RJ45/RJ45 Ethernet
cable, further referred to as LAN cable is included.
You can use LAN cables other than the one provided in the box. However make sure to
use correct connection cables.
Proceed as follows:
1
Use the included LAN cable to wire your computer's Ethernet port to (one of)
the SpeedTouch™610 Ethernet port(s).
2
For local networking, repeat step 1 for each computer.
Note
If an additional hub or switch is used, please follow the installation
instructions supplied with the hub or switch.
3
Use the included DSL cable to wire the SpeedTouch™610's Line port to your
telephone wall outlet or distributed filter.
4
Plug the power adapter's coaxial jack into the SpeedTouch™610 DC inlet.
Note
Always check first whether the included power adapter suits the local
power specifications.
For more information, see the application note "The SpeedTouch™ and Ethernet
Connectivity".
Once all connections are made the result should look similar as below:
E-SIT-CTC-20030306-0004 v2.0
Advertisement
Table of Contents
