BMW S 1000RR Rider's Manual page 79

is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. The
type of alarm tone can be set by
an authorised BMW Motorrad
dealer.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The DWA LED then indicates
the reason for the alarm for one
minute.
Light signals issued by the
DWA LED:
Flashes 1x: motion sensor 1
Flashes 2x: motion sensor 2
Flashes 3x: ignition switched
on with unauthorised vehicle
key
Flashes 4x: disconnection of
the anti-theft alarm from the
motorcycle's battery
Flashes 5x: motion sensor 3
DWA deactivating
Switch on the ignition.
Turn indicators flash once.
Confirmation tone sounds once
(if programmed).
Anti-theft alarm (DWA) is deac-
tivated.
Customising anti-theft
alarm settings
Switching on ignition (
Go to the Settings,
Vehicle settings, Alarm
system menu.
The following adaptation set-
tings are available:
Adapt Warning signal
Switch Tilt alarm sensor
on and off
Switch Arming tone on and
off
Switch Arm automatically
on and off
Possible settings
Warning signal: set the in-
creasing and decreasing or inter-
mittent alarm tone.
Tilt alarm sensor: activate
inclination sensor to monitor the
inclination of the vehicle. The
DWA responds, for example, to
wheel theft or being towed away.
NOTICE
60).
Deactivate the tilt sensor when
transporting the vehicle in or-
der to prevent the DWA from
tripping.
Arming tone: confirmation
alarm tone after having activated/
deactivated the DWA in addition
to flashing turn indicators.
4
77
z