BMW R 1250RS Rider's Manual page 168

cases the data stored in the
9
control units can be adapted for
the new wheel sizes.
166
TPC/RDC label
with tire pressure monitor
OE
(TPM)
z
ATTENTION
Improper tire removal
Damage to the TPC/RDC sen-
sors
Inform a specialist service
facility or an authorized
BMW Motorrad retailer on the
fact that the wheel is equipped
with a TPC/RDC sensor.
On motorcycles equipped with
TPC/RDC, a corresponding label
can be found on the rim at the
position of the TPC/RDC sen-
sor. When changing tires, ensure
that the TPC/RDC sensor is not
damaged. Inform the authorized
BMW Motorrad retailer or the
specialist workshop about the
TPC/RDC sensor.
Removing front wheel
Make sure ground is level and
firm and hold motorcycle verti-
cally.
OE
with center stand
Make sure the ground is level
and firm and place the motor-
cycle on its center stand.
Remove screw 1 and remove
wheel speed sensor from the
bore.
Mask off areas of wheel rim
that could be scratched in the
process of removing the brake
calipers.
ATTENTION
Unintentional pressing to-
gether of brake pads
Component damage when
mounting the brake caliper or
when pressing the brake pads
apart