Rolling The Sewing Unit; Removing The Transport Locks - DURKOPP ADLER 745-35-10 S Operating Instructions Manual

Setup

7.2.3 Rolling the sewing unit

Information
For in-house transport the stand can be equipped with 4 castors.
Fig. 181: Rolling the sewing unit
(1) - Castors
(2) - Stand feet
To roll the sewing unit:
1. To transport on castors, loosen the nuts (3) of the stand feet (2) and
2. When transport is complete, screw out the stand feet (2) until the cas-
3. Tighten the nuts (3).

7.2.4 Removing the transport locks

Remove all transport locks before setting up the sewing unit.
All moving parts must be unlocked:
Important
If you wish to transport the sewing unit to a different location, you have to
attach the transport locks again.
When removing/fitting the transport locks, also observe the information
given in the supplementary sheet included with the machine.
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
screw in the stand feet (2).
tors (1) lift off the ground.
• Transport carriage
• Method plate
• Corner knife station
• Feeder
• Assembly groups, e. g. stacker
①
(3) - Nuts
③
②
213