DURKOPP ADLER 745-35-10 S Operating Instructions Manual page 242

Error code Symbol
7201
7202
7209
7210
7211
7215
7219
7260
Error code 8000-8999: Error messages displays
8400 Information
8401 Information
8402 Information
8403 Information
8404 Information
8406 Information
8407 Information
8408 Information
8409 Information
8410 Information
240
Meaning
Failure in CAN - Module corner
knife (AC001), power failure
Failure in CAN - Module corner
knife (AC001), excess
temperature at step motor output
stage
Failure in CAN - Module corner
knife (AC001), wrong module
recognized at address
Failure in CAN - Module transport
unit (AC101), no module
recognized at address
Failure in CAN - Module transport
unit (AC101), power failure
Failure in CAN - Module transport
unit (AC101), outputs overload/
short circuit
Failure in CAN - Module transport
unit (AC101), wrong module
recognized at address
General error CAN modules
No readable update-program for the control panel available.
The control panel program should be updated as soon as possible.
Continue with OK
No valid program for the machine available. Should a new program be
transmitted?
Machine has a program for another class. Should a new program be
transmitted?
Machine has an outdated program. Should a new program be
transmitted?
Update failed! Eventually the control panel program has to be reloaded.
Should the program be retransmitted nevertheless?
Update failed! Please check the interface to the machine. Should a new
update be tried nevertheless?
Update failed! Should the program be retransmitted?
Waiting for RESET by machine.
Switch off and on the machine again.
Update failed! Should the program be retransmitted?
Operating Instructions 745-35-10 S/745-35-10 A - 03.0 - 04/2017
Troubleshooting
Remedial action
• Check cable
• Check jumpers
• Check voltage supply
• Check cable
• Check jumpers
• Check voltage supply
• Check output stage
• Check motors
Check jumpers/DIP switch
• Check cable
• Check jumpers
• Check voltage supply
• Check cable
• Check jumpers
• Check voltage supply
Check output cable and output plug
Check jumpers/DIP switch
Check cable