Oven Light Bulb Removal; Orifice Removal; Main Top Removal - Viking RVGR3305B Service Manual

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Oven Light Bulb Removal

DO NOT touch bulb with bare hands. Clean off any
signs of oil from the bulb and handle with a soft cloth.
1. Open oven door and unsnap glass light cover using a
screwdriver in the access groove.
2. Firmly grasp light bulb and pull out.
3. Replace with halogen bulb using volt and wattage
requirements listed on glass cover.
4. Replace the light cover by snapping glass cover onto
metal box.
1
3

Orifice Removal

1. Remove grates, burner caps, and burner heads from
burner base assembly.
2. Remove orifice from jet holder.
3. Reverse procedure for installation.
©2013 Viking Preferred Service
2
4

Main Top Removal

1. Remove the control panel assembly (see Control
Panel Assembly Removal).
2. Remove backguard assembly (see Backguard
Assembly Removal).
3. Remove grates, burner caps, and burner heads from
each burner base assembly.
4. Remove screws from each burner base assembly.
5. Remove screws and side trim from each side of
range.
6. Lift main top from range.
Note: Make sure to return insulation to original position
under each side trim.
7. Reverse procedure for installation.
Disassembly
29