Specifications - Mitsubishi Electric MELCEC Q Series User Manual

3.

SPECIFICATIONS

3 SPECIFICATIONS
The general specification common to various modules is shown.
Item
Operating ambient
temperature
Storage ambient
temperature
Operating ambient
humidity
Storage ambient
humidity
*4
Vibration resistance
Shock resistance
Operating atmosphere
*3
Operating altitude
Installation location
*1
Overvoltage category
*2
Pollution degree
Equipment class
Compliant Under
with JIS B intermittent
3502, IEC
vibration
61131-2
Under
continuous
vibration
Compliant with JIS B 3502 and IEC 61131-2 (147 m/s
*1 This indicates the section of the power supply to which the equipment is assumed to be
connected between the public electrical power distribution network and the machinery within
premises.
Category II applies to equipment for which electrical power is supplied from fixed facilities.
The surge voltage withstand level for up to the rated voltage of 300V is 2500V.
*2 This index indicates the degree to which conductive material is generated in terms of the
environment in which the equipment is used.
Pollution level 2 is when only non-conductive pollution occurs. A temporary conductivity
caused by condensing must be expected occasionally.
*3 Do not use or store the programmable controller under pressure higher than the atmospheric
pressure of altitude 0m. Doing so may cause malfunction. When using the programmable
controller under pressure, please consult your local Mitsubishi Electric representative.
Specifications
0 to 55
-20 to 75
10 to 90 % RH, No-condensing
Constant
Frequency
acceleration
5 to 9 Hz
–
9 to 150 Hz
9.8m/s
5 to 9 Hz
–
9 to 150 Hz
4.9m/s
2
, 3 times each in 3 directions X, Y, Z)
No corrosive gases
0 to 2000m
Inside a control panel
II or less
2 or less
Class I
3 - 1
Half amplitude Sweep count
3.5mm 10 times each
in X, Y, Z
2
–
directions.
1.7mm
2
–
–