Installing Batteries (Cpu Module And Memory Card Batteries) - Mitsubishi Electric MELCEC Q Series User Manual

7. MEMORY CARD AND BATTERY
7.6

Installing Batteries (CPU Module and Memory Card Batteries)

(1)
Open the cover at the bottom of the
CPU module.
Check if the battery is properly
inserted.
Check the orientation of the connector
attached to the housing and insert it
into the connector pin of the battery.
Completion
(2)
Set the battery holder's locking
switch to the "RELEASE" position.
Remove the battery holder from the
SRAM card.
Insert the battery into the battery
holder with the "+" face up.
Insert the battery holder with which
the battery is installed firmly, into the
SRAM card.
Check that the battery holder fixing
switch is set to the "LOCK" position.
Completion
Since the CPU module battery is shipped with its battery connector disconnected,
connect the connector according to the procedure indicated below.
POINT
Firmly push the connector all the way.
The battery for the SRAM card is shipped separately from the battery holder. To use
the SRAM memory, set the battery holder according to the procedure below.
Side of CPU
Bottom side Battery
"Model name"
Battery holder fixing switch
on this side
RELEASE
LOCK
* The battery holder fixing switch is set automatically to
the "LOCK" position when the battery holder is
removed. In its position, insert the battery holder firmly.
7 - 7
Connector
"+" sign
Battery holder
Front side