Specifications
This appendix provides general board specifications for the MVME2100
including mechanical, electrical and environmental specifications. It also
provides a section on EMC compliance, and a section on Thermal
Validation, including a listing of thermally significant components.
Mechanical Characteristics
The mechanical outline of the MVME2100 SBC conforms to the
dimensions of a standard 6U VMEbus form factor.
Electrical Characteristics
The estimated power requirements for the MVME2100 are as follows:
Table B-1. Power Requirements for the MVME2100
Configuration
250 MHz Processor
83.33 MHz Memory bus
Notes The power requirement listed for the MVME2100 does not
B
+5V Power
2.5A typical
3.5A maximum
include the power requirements for the PMC or PC•MIP
slots. The PMC specification allows for 7.5 watts per PMC
slot. The PC•MIP specification does not limit maximum
power per slot. A total of 15 watts can be drawn from any
combination of the four voltage sources provided by the
MVME2100: +3.3V, +5V, +12V, and -12V.
Specifications
+12V Power
N/A
N/A
B
-12V Power
N/A
N/A
B-1