Motorola MVME2100 Installation And Use Manual page 75

Auto-Initialize of NVRAM Header Enable [Y/N] = Y?
Network PReP-Boot Mode Enable [Y/N] = N?
Negate VMEbus SYSFAIL* Always [Y/N] = N?
SCSI Bus Reset on Debugger Startup [Y/N] = N?
Primary SCSI Bus Negotiations Type [A/S/N] = A?
http://www.motorola.com/computer/literature
NVRAM (PReP partition) header space will be
Y
initialized automatically during board initialization,
but only if the PReP partition fails a sanity check.
(Default)
NVRAM header space will not be initialized
N
automatically during board initialization.
Enable PReP-style network booting (same boot image
Y
from a network interface as from a mass storage
device).
Do not enable PReP-style network booting. (Default)
N
Negate the VMEbus SYSFAIL
Y
initialization.
Negate the VMEbus SYSFAIL
N
successful completion or entrance into the bug
command monitor. (Default)
Local SCSI bus is reset on debugger setup.
Y
Local SCSI bus is not reset on debugger setup.
N
(Default)
A Asynchronous SCSI bus negotiation. (Default)
Synchronous SCSI bus negotiation.
S
None.
N
ENV - Set Environment
∗
signal during board
∗
signal after
5-5
5