Introduction; Vmebus Connectors; Table C-1. P2 Connector Pin Assignment - Motorola MVME2100 Installation And Use Manual

CConnector Pin Assignments

Introduction

This chapter provides information on pin assignments for various
connectors on board the MVME2100 Single Board Computer.

VMEbus Connectors

VMEbus connectors P1 and P2 are the160-pin DIN type. Connector P1
provides power and VME signals for 24-bit address and 16-bit data. The
pin assignments for this connector are specified by the IEEE P1014-1987
VMEbus Specification and the VME64 Extension Standard.
Row B of connector P2 provides power to the MVME2100, the upper 8
VMEbus address lines, and additional 16 VMEbus data lines. Rows A, C,
Z, and D provide power and interface signals for the Type I PC-MIP and/or
PMC mezzanine boards. The pin assignments for connector P2 are as
follows:
Pin Row Z
1 PCMIP2 (P3-59)
2 GND
3 PCMIP2 (P3-55)
4 GND
5 PCMIP2 (P3-51)
6 GND
7 PCMIP2 (P3-47)
8 GND
9 PCMIP2 (P3-43)

Table C-1. P2 Connector Pin Assignment

Row A
PMC1(J14-2)
PMC1 (J14-4)
PMC1 (J14-6)
PMC1 (J14-8)
PMC1 (J14-10)
PMC1 (J14-12)
PMC1 (J14-14)
PMC1 (J14-16)
PMC1 (J14-18)
Row B Row C
+5V PMC1(J14-1)
GND PMC1 (J14-3)
NC PMC1 (J14-5)
VA24 PMC1 (J14-7)
VA25 PMC1 (J14-9)
VA26 PMC1 (J14-11)
VA27 PMC1 (J14-13)
VA28 PMC1 (J14-15)
VA29 PMC1 (J14-17)
C
Row D
PCMIP2(P3-60)
PCMIP2 (P3-57)
PCMIP2 (P3-56)
PCMIP2 (P3-54)
PCMIP2 (P3-52)
PCMIP2 (P3-49)
PCMIP2 (P3-48)
PCMIP2 (P3-46)
PCMIP2 (P3-44)
C-1