Secondary Pmcspan - Motorola MVME2100 Installation And Use Manual

Preparation and Installation
1

Secondary PMCspan

1-14
4. Attach the four standoffs to the MVME2100 module. For each
standoff:
– Insert the threaded end into the standoff hole at each corner of
the VME processor module.
– Thread the locking nuts onto the standoff tips.
– Tighten the nuts with a box-end wrench or a pair of needle nose
pliers.
5. Place the PMCspan on top of the MVME2100. Align the mounting
holes to the standoffs in each corner, and align PMCspan connector
P4 with MVME2100 connector J4.
6. Gently press the PMCspan and MVME2100 together, making sure
that P4 is fully seated in J4.
7. Insert the four short Phillips screws through the holes at the corners
of the PMCspan and into the standoffs on the MVME2100. Tighten
the screws.
The PMCspan-010 PCI expansion module mounts on top of a PMCspan-
001 PCI expansion module. To install a PMCspan-010 on your
MVME2100, refer to Figure 1-6 on page 1-15
steps:
Note This procedure assumes that you have read the user's manual that
was furnished with the PMCspan, and that you have installed the
selected PMCs on the PMCspan according to the instructions given
in the PMCspan and PMC manuals.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. The ESD strap must be secured to
your wrist and to ground while you are performing the installation
procedure.
2. Perform an operating system shutdown. Turn the AC or DC power
off and remove the AC cord or DC power lines from the system.
and perform the following
Computer Group Literature Center Web Site