Motorola MVME2100 Installation And Use Manual page 79

ROM Boot Direct Ending Address = FFFFFFFC?
The last location tested when PPCBug searches for a ROMboot
module. (Default = 0xFFFFFFFC)
Network Auto Boot Enable [Y/N] = N?
Network Auto Boot at power-up only [Y/N] = N?
Network Auto Boot Controller LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing
of network controller modules currently supported by PPCBug.
(Default = 0x00)
Network Auto Boot Device LUN = 00?
Refer to the PPCBug Firmware Package User's Manual for a listing
of network controller modules currently supported by PPCBug.
(Default = 0x00)
Network Auto Boot Abort Delay = 5?
The time in seconds that the NETboot sequence will delay before
starting the boot. The purpose for the delay is to allow you the option
of stopping the boot by use of the
0 - 255 seconds. (Default = 5 seconds)
Network Auto Boot Configuration Parameters Offset (NVRAM) =
00001000?
The address where the network interface configuration parameters are
to be saved/retained in NVRAM; these parameters are the necessary
parameters to perform an unattended network boot. A typical offset
might be 0x1000, but this value is application-specific.
Default = 0x00001000.
http://www.motorola.com/computer/literature
Y The Network Auto Boot (NETboot) function is
enabled.
The NETboot function is disabled. (Default)
N
NETboot is attempted at power-up reset only.
Y
NETboot is attempted at any reset. (Default)
N
ENV - Set Environment
key. The time value is from
BREAK
5
5-9