Using Ppcbug - Motorola MVME2100 Installation And Use Manual

27. Calculates and displays the MPU clock speed, verifies that the MPU
28. Displays the bus clock speed, verifies that the bus clock speed
29. Probes PCI bus for supported network devices.
30. Probes PCI bus for supported mass storage devices.
31. Initializes the memory/IO addresses for the supported PCI bus
32. Executes Self-Test, if so configured. (Default is no Self-Test.)
33. Extinguishes the board fail LED, if Self-Test passed, and outputs
34. Executes boot program, if so configured. (Default is no boot.)
35. Executes the debugger monitor (i.e., issues the

Using PPCBug

PPCBug is command-driven; it performs its various operations in response
to commands that you enter at the keyboard. When the PPC5-Bug prompt
appears on the screen, the debugger is ready to accept debugger
commands. When the PPC5-Diag prompt appears on the screen, the
debugger is ready to accept diagnostics commands. To switch from one
mode to the other, enter SD.
What you enter is stored in an internal buffer. Execution begins only after
you press the <Return> or <Enter> key. This allows you to correct entry
errors, if necessary, with the control characters described in the PPCBug
Firmware Package User's Manual.
After the debugger executes the command, the prompt reappears.
However, depending on what the user program does, if the command
causes execution of a user target code (i.e., GO), then control may or may
not return to the debugger.
http://www.motorola.com/computer/literature
clock speed matches the configuration data, and displays a warning
message if the verification fails.
matches the configuration data, and displays a warning message if
the verification fails.
devices.
any warning messages.
Using PPCBug
prompt).
PPC5-Bug>
4-5
4