Motorola MVME2100 Installation And Use Manual page 77

Auto Boot at power-up only [Y/N] = N?
Auto Boot Scan Enable [Y/N]
Auto Boot Scan Device Type List = FDISK/CDROM/TAPE/HDISK?
This is the listing of boot devices displayed if the Autoboot Scan
option is enabled. If you modify the list, follow the format shown
above (uppercase letters, using forward slash as separator).
Auto Boot Controller LUN
Refer to the PPCBug Firmware Package User's Manual for a listing
of disk/tape controller modules currently supported by PPCBug.
(Default = 0x00)
Auto Boot Device LUN
Refer to the PPCBug Firmware Package User's Manual for a listing
of disk/tape devices currently supported by PPCBug.
(Default = 0x00)
Auto Boot Partition Number = 00?
Which disk "partition" is to be booted, as specified in the PowerPC
Reference Platform (PReP) specification. If set to zero, the firmware
will search the partitions in order (1, 2, 3, 4) until it finds the first
"bootable" partition. That is then the partition that will be booted.
Other acceptable values are 1, 2, 3, or 4. In these four cases, the
partition specified will be booted without searching.
http://www.motorola.com/computer/literature
Autoboot is attempted at power-up reset only.
Y
Autoboot is attempted at any reset. (Default)
N
= Y?
If Autoboot is enabled, the Autoboot process attempts
Y
to boot from devices specified in the scan list (e.g.,
FDISK/CDROM/TAPE/HDISK
If Autoboot is enabled, the Autoboot process uses the
N
Controller LUN and Device LUN to boot.
= 00?
= 00?
ENV - Set Environment
). (Default)
5-7
5