Figure 1-4. Typical Type II PC•MIP Placement on an MVME2100
6. Insert the appropriate number of Phillips head screws (typically 2)
Primary PMCspan
To install a PMCspan-001 PCI expansion module on your MVME2100,
refer to the PMCspan PMC Adapter Carrier Board Installation and Use
manual, listed in
on page
Dangerous voltages, capable of causing death, are present in
this equipment. Use extreme caution when handling, testing,
Warning
and adjusting.
http://www.motorola.com/computer/literature
through the holes of the PMC module or PC•MIP card(s), into the
mating standoffs on the MVME2100 and tighten the screws.
Related Documentation on page
1-13, and perform the following steps:
Installing the MVME2100 Hardware
A-1, refer to
1
Figure 1-5
1-11