Configuring The Vmebus Interface - Motorola MVME2100 Installation And Use Manual

Modifying the Environment
5

Configuring the VMEbus Interface

5-12
Serial Startup Code Master Enable [Y/N]=N?
A line feed can be inserted after each code is displayed to prevent it
from being overwritten by the next code. This is also enabled by an
ENV parameter:
Serial Startup Code LF Enable [Y/N]=N?
The list of LED/serial codes is included in the section on MPU,
Hardware, and Firmware Initialization in the PPCBug Firmware
Package User's Manual, as listed in Appendix A,
Documentation.
ENV asks the following series of questions to set up the VMEbus interface
for the MVME2100. To perform this configuration, you should have a
working knowledge of the Universe ASIC as described in your
MVME2100 Programmer's Reference Guide.
VME3PCI Master Master Enable [Y/N] = Y?
Y
N
PCI Slave Image 0 Control = 00000000?
The configured value is written into the LSI0_CTL register of the
Universe chip.
PCI Slave Image 0 Base Address Register = 00000000?
The configured value is written into the LSI0_BS register of the
Universe chip.
PCI Slave Image 0 Bound Address Register = 00000000?
The configured value is written into the LSI0_BD register of the
Universe chip.
PCI Slave Image 0 Translation Offset = 00000000?
The configured value is written into the LSI0_TO register of the
Universe chip.
Set up and enable the VMEbus Interface. (Default)
Do not set up or enable the VMEbus Interface.
Computer Group Literature Center Web Site
Related