Siemens SIMATIC IPC647D Operating Instructions Manual page 113

Refresh
Load Driver
Delete
Extend
Format
New
Note
If you want to install the operating system on a data medium connected to a storage
controller unknown to the operating system, you have to integrate the driver of the storage
controller. Integrate this driver before you partition the data medium and before you install
the operating system. For more information on integrating the storage controller, refer to the
section "Information for systems with RAID or AHCI controller".
1. Make sure that the partition on which you want to install the operating system is large
2. Select the partition on which you want to install the operating system.
3. Click "Next".
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
Updating
Integration of controller drivers unknown to the operating system and required for
installation. Please read the information in the section "Information for systems
with RAID or AHCI controller".
Deleting a partition
Changing the partition size
Formatting a partition
Creating new partitions
Identification for error messages, for example, if the data medium was not
formatted in the required "NTFS" format.
enough and is set up with a NTFS file system.
The recommended minimum size of this partition varies, depending on the operating
system, how much RAM you have available and how much additional software you want
to use. Information on how the data medium is partitioned in its factory state is available
in the tables below.
Installation is started. The Windows operating system is installed on the data medium.
Device maintenance and repair
7.5 Installing the software
113