Raid System And Device Startup - Siemens SIMATIC IPC647D Operating Instructions Manual

A.3

RAID system and device startup

Problem
The RAID software reports
the following errors:
The RAID plug-in failed
•
to load, because the
drive is not installed.
The Serial ATA plug-in
•
failed to load, because
the driver is not installed
correctly.
The Intel Matrix
• ®
Storage Console was
unable to load a page
for the following reason:
– A plug-in did not
provide a page for
the selected device
– A plug-in failed to
load
After changing the drive, the
system does not boot from
the RAID system
After changing the drive,
"unused" is indicated for the
relevant SATA port
Computer does not boot or
"Boot device not found" is
displayed
The startup of a Windows
operating system on a GPT
data carrier is aborted with
the following error message:
"Status: 0xc0000225 Info:
The boot selection faild
because a required device
is inaccessible"
SIMATIC IPC647D
Operating Instructions, 01/2014, A5E32996306-AA
Cause
RAID is not activated
RAID is activated
RAID system does not have highest
boot priority
System was booted without functioning
drive. The removable drive bay might
not be switched on.
The boot device is not permitted
•
The boot device is not in first place
•
of the boot priority in the BIOS
setup
The boot data carrier is set up with
•
GPT and UEFI boot is deactivated
in the BIOS setup
The boot parameters in the boot loader
file "BCD" are incorrect or damaged.
A.3 RAID system and device startup
Remedy
The messages have no negative effect on the
operation of the device and can be ignored.
Acknowledge the messages.
Install the software again from the supplied
"Documentation and Drivers" DVD.
BIOS setup, Boot menu:
Permit RAID system in the boot priority
•
Set the RAID system to be first in the boot
•
priority order.
Reboot the system with a functioning drive.
In the BIOS setup "Boot" menu, permit the boot
•
device in the boot priority
In the BIOS setup "Boot" menu, change the
•
boot priority of the Boot device
Activate UEFI boot in the BIOS setup.
•
Execute "Startup and Repair" from Microsoft
Windows:
1. Insert the Recovery DVD into the optical drive.
2. Select the line with "UEFI" in front of the name
of the optical drive.
3. Click "Next" in the language selection window.
4. In the following "Install Windows" dialog, click
on "Repair your computer" or press the <R>
key. The "System Recovery Options" dialog
appears. The system is checked for errors.
5. Next, click "Repair and restart".
Technical support
195