Table of Contents
Advertisement
Log Set Installation
Read the instructions below carefully and refer to the
diagrams. If logs are broken do not use the unit until
they are replaced. Broken logs can interfere with the
pilot operation.
The gas log kit (Part #780-930) contains the following
pieces:
a) 02-75
Rear Log
b) 02-55
Middle Left Log
c) 02-50
Front Left Log
d) 02-53
Center Left Log
e) 02-51
Front Bottom Log
f) 02-54
Center Right Log
g) 02-52
Middle Right Log
h) 902-156
Embers
i) 902-179
Vermiculite
j) 946-669
Platinum Embers
NOTE: If you will be installing the optional Brick Panels
(P36D & P90 only), install the Brick Panels prior
to installing the logs.
Model shown has P36D and P90 burner/grate with
brick panel option.
02-51
02-53
02-50
The "02" reference numbers (i.e. 02-75) are
molded into the rear of each log.
1)
Carefully remove the logs from the box and unwrap them.
The logs are fragile, handle with care - do not force into
position.
2)
Sprinkle the vermiculite over base brick panel.
918-067c
LOG SET INSTALLATION
(supplied with packaged manual)
02-75
02-54
02-55
02-52
3)
Place the Log 02-75 on the rear log support pins with the
fl at side to the back.
02-75
4)
Place Log 02-51 on the front right side of the burner. Push
the back of the log against the 2 brackets with the notch
on the bottom right side of the log fi tting into the right side
of the grate.
02-75
Bracket
Page 1 of 4
Regency Excalibur
P36D / P90
02-51
Bracket
02-51
Notch
P90E-11 Direct Vent Gas Stove
®
installation
Notch
01/04/08
|
43
Advertisement
Table of Contents
