Table of Contents
Advertisement
Birchwood Log Set Installation
LOG SET INSTALLATION
Read the instructions below carefully and refer to the
diagrams. If logs are broken do not use the unit until
they are replaced. Broken logs can interfere with the
pilot operation.
The gas Birchwood log kit contains the following pieces:
The birchwood gas log set (Part #780-932) contains the following pieces:
A
Rear Log
Middle Left Log
B
Front Left Log
C
D
Center Left Log
E
Front Bottom Log
F
Center Right Log
Middle Right Log
G
902-156
Embers
902-179
Vermiculite
946-669
Platinum Embers
NOTE: If you will be installing the optional Brick Panels
install the Brick Panels prior to installing the logs.
Model shown P90 without Brick Panels installed.
D
C
1.
Carefully remove the logs from the box and unwrap them.
The logs are fragile, handle with care - do not force into
position.
Sprinkle the vermiculite over base brick panel.
2.
919-954
(supplied with packaged manual)
A
E
B
G
3.
Place the Log A on the rear log support pins with the fl at
side to the back.
4)
Place Log 02-51 on the front right side of the burner. Push
the back of the log against the 2 brackets with the notch
on the bottom right side of the log fi tting into the right side
of the grate.
F
Bracket
Page 1 of 4
Regency Excalibur
BIRCHWOOD LOGSET
A
E
Bracket
E
P90E-11 Direct Vent Gas Stove
®
installation
Notch
Notch
11.08.18
|
47
Advertisement
Table of Contents
