Table of Contents
Advertisement
installation
Unit Assembly
Prior To
Installation
The 2 Top Standoffs must be correctly positioned
and attached to the top before unit is slipped into
position.
Top Standoff Assembly
The top standoffs are shipped in a flat position and
must be folded into shape and attached.
1. Remove the standoffs from the fireplace top.
2. Take each standoff and bend into the correct
shape. Bend up at the bend lines until the screw
holes in the standoff and the pre-punched screw
holes on the fireplace top line up.
3. Attach the standoff securely to the top with 2
screws per standoff (on opposite corners).
Side Nailing Strips
The side nailing strips come attached to the unit.
There are 2 plates, one on the top and bottom that
can be folded out as required.
Plates can be
folded out.
|
22
Regency Excalibur
Venting
Introduction
The P90E-11 uses the "balanced flue" technology
Co-axial system. The inner liner vents products
of combustion to the outside while the outer liner
draws outside combustion air into the combustion
chamber thereby eliminating the need to use heated
room air for combustion and losing warm room air
up the chimney.
Note:
The gas appliance and vent system must be vented
directly to the outside of the building, and never
be attached to a chimney serving a separate solid
fuel or gas burning appliance. Each direct vent gas
appliance must use it's own separate vent system.
Common vent systems are prohibited.
P90E-11 Direct Vent Gas Stove
®
These flue pipes must not be connected
to any other appliance.
Advertisement
Table of Contents
